Shopping: Real Estate |  Costumes  |  Guitars
This Issue Archived Articles Blog About Us Contact Us
SEARCH


Water-Blasting Cannons and Shopping Trolleys...

How Ford in the US is developing safety systems - it's very weird!

Courtesy of Ford

Click on pics to view larger images


Click for larger image

The Ford Motor Company in the US is now ramming shopping carts into car doors and blasting water cannons to force vehicles into skids. These tests are part of Ford’s ongoing efforts to accelerate new collision protection and avoidance technologies. 

“These novel tests may seem over the top, but they’re part of a serious testing regimen that Ford had to invent, because increasingly sophisticated technologies require more advanced testing,” said Sue Cischke, group vice president, Ford Sustainability, Environment and Safety Engineering. 

New Tests for a New Technology

Click for larger image

Ford engineers conduct unusual “crash” tests to take thousands of impact readings that help calibrate the sensitivity of new air bag pressure sensors being introduced on the F-150 and Taurus.  The new air bag systems use pressure pulses from a side impact to deploy up to 30 percent faster than a traditional air bag system that uses acceleration-based sensors.

Engineers, however, were concerned that everyday mishaps – such as shopping cart collisions in parking lots or errant basketballs from neighbourhood children – could trick the new sensors that now help predict crash forces before the full impact occurs.  The engineers used reams of data from these unusual tests to calibrate the air bag sensor to disregard typically minor collisions.

Click for larger image

In one test, a lab robot repeatedly pushes a shopping cart loaded with a 110-pound weight into the vehicle doors at 10 miles per hour. 

Click for larger image

Another robotic test replicates the impact of a bicycle wheel on the car door.

Pressure-based sensors more accurately measure the severity of a crash than acceleration-based sensors, which makes them better able to differentiate between a life-threatening, air bag-deployable crash and relatively harmless daily abuse that should not require air bag protection. 

They also perform better in new US federal side-impact and oblique-impact tests, are less likely to be affected by vehicle design differences, and give designers more flexibility because they take up less space.

Whipped, Stirred and Shaken

Click for larger image

Engineers also conduct air bag sensor research on a test track rife with jarring, jolting surface imperfections, ranging from potholes and chatter bumps to curbs and ditches.  There, certified test drivers are encouraged to push vehicles to the limit.

Click for larger image

“They drive the test vehicles into curbs and railroad tracks at high speeds,” said Todd Clark, sensor development supervisor, Ford Safety Systems.  “Most people wouldn’t drive that recklessly, but it’s our job to find out how much abuse the sensor will take before deploying the air bag - and adjust the sensors accordingly.”

Click for larger image

Ford’s safety engineers also have concocted a clever test method using a multi-tailed, lead-tipped steel whip. They use it to repeatedly “pepper” the underbody area where side impact air bag sensors are located.  Data collected from such tests is also used to refine sensor calibration.

From Pumpkin Patch to Test Track

Click for larger image

Ford researchers also use a water cannon test to analyse how a moving vehicle reacts to being struck from the side, without putting test vehicles and drivers at risk of damage or injury. Researchers say the new test could prove useful in the development of next-generation stability control technology.

Click for larger image

In this highly coordinated manoeuvre, Ford engineers mount an air-powered cannon – a tool commonly used in mining operations and pumpkin-throwing contests – in the rear compartment of a test vehicle.  The cannon blasts water outward, causing a recoil impulse that forces the vehicle into a skid.  Engineers use the test data in computer simulations to help study how to enhance stability control technology, reducing risks to test drivers and damage to test vehicles.

Cannon facts:

  • The tank that supplies the water cannon holds about nine gallons

  • The compressed air is charged to 130 psi

  • The recoil impulse of the water discharge takes less than one-half second

  • Reaction of the vehicle to the sudden recoil takes about five seconds

  • Testing is done on both dry and wet asphalt to check vehicle reactions on a variety of surfaces and conditions

Click for larger image

“It’s a very effective test that demonstrates the ingenuity of our engineering team to think outside the box,” said Jeff Rupp, manager, Ford Active Safety Systems Engineering.  “We know of no other automaker doing anything quite like it.”

Did you enjoy this article?

Please consider supporting AutoSpeed with a small contribution. More Info...


Share this Article: 

More of our most popular articles.
The most amazing flying machines you've ever seen

Smart Technology - 5 March, 2002

Between the Wind and the Waves: Ekranoplans

An astonishing car

Special Features - 20 May, 2014

The Rumpler Tropfenwagen

Do-it-yourself aero testing of an Impreza WRX

Technical Features - 23 June, 2007

Aero Testing, Part 2

The revs and loads at which engines use least fuel

Technical Features - 10 April, 2008

Brake Specific Fuel Consumption

Building a programmable temperature alarm

DIY Tech Features - 20 October, 2009

eLabtronics EZ System, Part 3

A brilliant new temperature controller that's so cheap it's unbelievable.

DIY Tech Features - 15 November, 2011

$25 Temperature Controller and Display!

Perhaps the most sophisticated human powered vehicle you've ever seen

DIY Tech Features - 17 December, 2007

Air 150 Recumbent Trike, Part 1

Getting planning approval

DIY Tech Features - 7 February, 2012

A New Home Workshop, Part 3

DIY building of very light vehicles from steel tube

DIY Tech Features - 17 March, 2009

Building Ultra Light-Weight Tubular Frame Vehicles, Part 1

Huge lights without a roo- or nudge-bar

DIY Tech Features - 2 October, 2012

Mounting big driving lights, Part 1

Copyright © 1996-2020 Web Publications Pty Limited. All Rights ReservedRSS|Privacy policy|Advertise
Consulting Services: Magento Experts|Technologies : Magento Extensions|ReadytoShip